Testing Solar Panels on a Multimeter
I have 4 solar panels at home and I wanted to find out the voltages for each of them. So I set a simple experiment where I used a multimeter to test the power of each panel. The Multimeter gave me unreliable results. I found this out when I finally tested it on my 9 V battery. [ go to Youtube.com ]
Time
: 4 min
09
Added
: 17/02/08 19:07
Send with Gmail
Videos
(18)
|
Blog posts
(20)
Jensen 5 - Generator series 1
Time for some learnin' fun. Got a new multimeter that I can actually read, so I decided to test the generators with the Jensen model 5 to see how they do. We're just starting up here so it takes a bit of time to build up speed. Tops out at about 13.4VDC [
go to Youtube.com
]
Time
: 2 min
34
Added
: 01/09/07 06:05
Send with Gmail
CH-Racing Husqvarna WSM 50 Spezial
Weil es draussen geregnet hat dachte ich, ich könnte mal schauen wieviel meine CHR so dreht. U/min [
go to Youtube.com
]
Time
: 0 min
47
Added
: 08/12/07 19:26
Send with Gmail
Multimeter Help On EX500 Solenoid Problem
My bike was having problems with the starter solenoid (aka relay) and so I bought a multimeter to test if I was getting any current. [
go to Youtube.com
]
Time
: 0 min
50
Added
: 24/07/07 09:30
Send with Gmail
Made a mistake with multimeter...
I was in the classroom testing my multimeter for the first time. I already measured voltage of the socket before. That worked fine.
Now i wanted to knom the amperes, so i confrigured it for amperes. I put in the contacts, and boom :P
(background voice is dutch) [
go to Youtube.com
]
Time
: 0 min
17
Added
: 15/05/07 18:59
Send with Gmail
Motor Testing
Testing the stepper motors with rectifiers to even out the current. Measuring with multimeter [
go to Youtube.com
]
Time
: 0 min
09
Added
: 14/06/07 19:08
Send with Gmail
setting gains w/ dmm...
this is a vid of me setting my amp gains to 40v w/ a fluke digital multimeter. 40v @ 2ohms = 800watts rms
set using a 50hz 0db test tone. [
go to Youtube.com
]
Time
: 9 min
Added
: 26/10/07 08:18
Send with Gmail
IIT VTOL aircraft prototype testing for lift
The lift measurement of a prototype VTOL aircraft is being performed using a measurement system consisting of a load cell, an electronic amplifier circuit and a multimeter (to name a few)
This is the custom-built IIT based VTOL prototype with dual wings rotating in the opposite direction.
This was under the guidance of Professor Fransisco Ruiz.
This has been a research project conducted for 'Engineering Measurements' Class in the MMAE Department at IIT. [
go to Youtube.com
]
Time
: 0 min
17
Added
: 09/12/07 01:51
Send with Gmail
Got pulse? Easy tips to make sure you're getting pulses out.
you're tring to trigger an instrument and your oscilloscope is not the easiest thing in the workd to use? Pulses are nothing more than a short burst of electric current, you could easily tell if you're getting a pulse out by using a multimeter. Every time you get a pulse you should see a burt or electric current, in this video we're using a model 565 from berkeley nucleonics. [
go to Youtube.com
]
Time
: 1 min
17
Added
: 22/01/07 21:31
Send with Gmail
Poormans Gauss Meter
Here i have built 2 gauss meters, one using a pic to give a readout of the gauss level and the other one uses a standard multimeter to give you a reading in volts, See http://my.execpc.com/~rhoadley/magmeter.htm for more construction details [
go to Youtube.com
]
Time
: 2 min
42
Added
: 26/02/07 00:04
Send with Gmail
1 -
10
of
18
Videos
Page:
First
| <
Preceding
|
Next
>
0
|
1
