7-TUBES ELECTRODE HHO OVERUNITY HYDROGEN GENERATOR

best hydrongen production compared to my other experimental cells. Smaller tube is 1/4"x 4" and bigger tube is 1/2" grade 316 Stainless steel wall 1/32" thick. consumed 13vdc 1.6amp, container diameter= 3" the disc rings holding the tube are 2" dia. will install this unit into my car and step up the voltage to 200vdc [ go to Youtube.com ]

Time : 1 min 19
Added : 28/01/08 11:10
Send with Gmail

Videos (85) | Blog posts (20)

-> Watch more videos directly on Youtube.com :

Pulse motor Typ SG ..

singel Pwr & trigger Coil gonna wind up a new Bi-coil then ill test this more .,, [ go to Youtube.com ]

Time : 0 min 33
Added : 14/02/08 01:46
Send with Gmail

Back top

New information on my Bedini Motor Generator Battery Charger

I made a switch that I can switch the charge and drive batteries back and forth. I also included some new meter readings and show a new bridge rectifier in line [ go to Youtube.com ]

Time : 4 min 57
Added : 13/02/08 06:04
Send with Gmail

Back top

High Voltage Fun!

39.8 seconds of buzzing, crackling fun with a newly-built "Jacob's Ladder" device, about half a meter tall, connected to an automotive ignition coil driven by a line-powered SCR pulse generator circuit with a capacitive ballast. More scientific fun at http://www.GregsLab.com ... [ go to Youtube.com ]

Time : 0 min 39
Added : 06/05/06 21:39
Send with Gmail

Back top

Moving forward with the Resin

I encased the magnets and coil to the resin. It only took 2 hours to set. I found other resin at lowes, it flows MUCH better than the jelly stuff at autozone. And Elmers Glue makes it "a name you can trust" hehe Thanks for watching. [ go to Youtube.com ]

Time : 2 min 31
Added : 18/01/08 19:39
Send with Gmail

Back top

stumbled onto part three

shows the pulsed hho cell produceing voltage by putting the - of the cell through a cap to one side of the coil and the other side of the coil goes back to the +,that creates amagnetic pulse, the other coil (bifilar) acts as a generator collecting the magnetic pulses. rember rate or comment its my only pay. [ go to Youtube.com ]

Time : 3 min 06
Added : 29/02/08 12:46
Send with Gmail

Back top

Pulse Motor (New 4 Coil HD Idea) 018

I will get a torc drive set tommorrow and Build this. I can put the top back on the HD once assembled to make sure the magnets do no kill me....lol The one in the last video shed its Magnets at high speed and splatted them up the walls, be warned if you are reproducing these videos...... [ go to Youtube.com ]